Webasto ThermoConnect TCon2 Operating And Installation Instructions page 7

>3 cm
Fig. 6
WARNING
Risk of failure
Installation close to metal surfaces im-
pairs the antenna reception. It can also
cause damage to the device.
Do not install the ThermoConnect
u
TCon2 on metal surfaces.
For optimal reception of the mobile net-
work and the GPS signal becomes one in-
stallation in the upper area of the dash-
board recommended. Fig. 7 shows the re-
commended area.
9040092D
Fig. 7
Recommended area
WHE000224A
Moderate range
Not recommended area
10.5 Installation of the
pushbutton
1
Fig. 8
Pushbutton
NOTE
Do not disconnect the connector from
the cable.
NOTE
The pushbutton must be installed.
NOTE
The pushbutton includes a temperat-
ure sensor. Make sure that the air can
WHE000225A
flow around the pushbutton at the in-
stallation location, but the pushbutton
must be shielded from direct air flow
from ventilation ducts.
NOTE
The pushbutton must be located
within the driver's field of view and
operation.
The pushbutton has four functions:
1. Switch the heater on/off.
2. Acknowledge new users.
3. Measure the temperature.
4. Reset or restart, see chapter 6.1 "Re-
start" on page 4/chapter 6.2 "Settings
reset" on page 5.
u Plug on the ThermoConnect TCon2 wir-
2
ing harness.
WHE000045A
u Install the pushbutton at an accessible
location, a protected area.
Wiring harness
– Make sure the illumination is visible dur-
ing operation.
EN
7