Advertisement
Quick Links
Advertisement
Related Manuals for Webasto Telestart T99
Summary of Contents for Webasto Telestart T99
- Page 1 Operating- and Installation Instructions Telestart T99...
- Page 2 1.1 Purpose of the document ......... 3 12 Maintenance and handling.......... 9 1.2 Using this document.......... 3 13 Installation overview Telestart T99 ........ 10 1.3 Use of symbols and highlighting ....... 3 14 Scope of delivery .............. 11 2 Intended use .............. 3 14.1 Control elements (optional)........ 11...
- Page 3 Telestart T99. and hazardous goods (e.g., pet- are available from Webasto at https:// These Operating and Installation In- rol stations, tank facilities, fuel dealers.webasto.com.
- Page 4 Telestart T99 Webasto Thermo & Comfort SE When pressing the transmitter, hold it Switching off heater or ventila- DANGER vertically upwards and do not cover the tion Risk of injury from the defective top (see figure). ON + Changing the operating mode, unit see "Heating or ventilation oper-...
- Page 5 Webasto Thermo & Comfort SE Telestart T99 Set the vehicle fan to the lowest set- Change operating mode Display operating time ting (lower power consumption). Heating or ventilation operating mode Display operating mode WHE000077A WHE000077A Fig.4 Fig.5 Briefly press the ON and OFF push...
- Page 6 Telestart T99 Webasto Thermo & Comfort SE Press the OFF push button within 10 Switching the heater NOTE s after the operating time indicator Permanent mode is only suitable or ventilation on and lights up. for use with continuous opera- The indicator lamp flashes according tion heaters.
- Page 7 (approx. 4 s.) and then goes transmitter (approx. 4 s.) and then goes out. out. The hand-held transmitter Telestart T99 u Repeat this procedure at a u Repeat this procedure at a must be paired with the Telestart re- different location with better different location with better ceiver in the vehicle.
- Page 8 Telestart T99 Webasto Thermo & Comfort SE 10.2 Teaching the unit Never expose the battery to high 2 - 6 s heat. Do not transport the battery together with metal objects, e.g. necklaces or hair pins. The risk of the battery leaking is greatest when the battery is dis- charged.
- Page 9 Webasto Thermo & Comfort SE Telestart T99 11.1 Battery disposal Maintenance and handling Batteries and electronic devices are Battery and hand-held transmitter: subject to the current versions of nAvoid damage the European Directive 2006/66/EC nDo not let it heat up over 70 °C (e.g.
- Page 10 Telestart T99 Webasto Thermo & Comfort SE Installation overview Telestart T99 Disc antenna UniControl (option) Male connector for heaters Telestart receiver MultiControl (option) Control element connection of the heater ESVT adapter (Telestart wiring har- Push button (option) ness) Extra control element (optional)
- Page 11 Check the completeness of the deliv- u One of the control elements ery. shown must be installed in Check the complete delivery for addition to the Telestart T99 damage. Fig.13 to be able to switch off the heater in an emergency.
- Page 12 16.2 Installing the aerial NOTE Install the aerial cable as follows: The Telestart T99 must be in- route the aerial cable under the < 300 mm stalled in the interior of the vehicle headliner trim, along the left vehicle.
- Page 13 Webasto Thermo & Comfort SE Telestart T99 16.3 Installing the ESVT Adjusting the ESVT adapter (Tele- start wiring harness) pin assign- adapter (Telestart ment wiring harness) NOTE ü The ESVT adapter has been adap- The pins are factory fitted on ted (for W-bus or analogue mode).
- Page 14 Telestart T99 Webasto Thermo & Comfort SE 16.5 Installing the control element The analogue switch input on the Tele- start T99 is set at the factory for opera- tion together with a push button. MultiControl and UniControl Connect the control element to the connector of the ESVT adapter.
- Page 15 Webasto Thermo & Comfort SE Telestart T99 The Telestart T99 was developed, man- ufactured, tested and supplied in ac- cordance with the relevant directives, regulations and standards for safety, EMC and environmental compatibility. Webasto declares that the product Telestart T99 is manufactured and de- livered in accordance with the direct- ives and regulations.
- Page 16 Telestart T99 Webasto Thermo & Comfort SE 17.3 Technical data Hand-held transmitter Basic functions ON, OFF, heating, ventilation Status indicator LED (red/green/orange) Size L/W/H [mm] 61.8 x 32.9 x 13.9 Weight [g] 32 (including battery) Transmitting power [dBm] Transmitting frequency [MHz] 869.0...
- Page 17 These are the original instructions. The German language is binding. You can request your language if it is missing. The telephone number of each country can be found in the Webasto service centre leaflet or the website of the respective Webasto representative of your country.
Need help?
Do you have a question about the Telestart T99 and is the answer not in the manual?
Questions and answers