RAB HAZL34-40 Instructions

INSTRUCTIONS
HAZL34™ INSTALLATION
RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi cient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We'd love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts inside.
CAUTION: TO REDUCE THE RISK OF IGNITION OF HAZARDOUS ATMOSPHERES, DISCONNECT THE LUMINARE FROM SUPPLY CIRCUIT
BEFORE OPENING. KEEP TIGHTLY CLOSED WHEN IN OPERATION.
CLASS I DIV. 2 GROUP A, B, C, D.
MIN. 90°C SUPPLY CONDUCTORS.
REFER TO TOOL LIST ON PAGE #4

PENDANT MOUNT

The fi xture is suitable for wet locations.
1. Open the Driver Box Cover by removing Silicone Covers and
loosening Captive Screws as shown in Fig. 1. Tether Cable will prevent
the Driver Box Cover from falling out.
2. Remove the threaded Knockout Plug (Fig. 1). Attach the Pendant
(by others) to the Fixture (Fig. 2). Use appropriate thread sealer. Tighten
the Set Screw to secure the Pendant (Fig. 3).
3. Pass the supply wires in the Pendant through the Knockout,
connect to the Terminal Block (Fig. 2) using proper polarity.
Note: Torque value 4.4 inch-lbs.
4. Replace the Driver Box Cover with Captive Screws (Fig.4) and
tighten to a minium of 2.5 N. M. and replace Silicone Covers.
WARNING: To prevent wiring damage or abrasion, do not expose
wiring to edges of sharp objects.
Fig: 2
Pendant
Figure 15
HAZL34-40
Set Screw
Terminal Block
HAZL34-80
HAZL34-120
Fig: 1
Tether Cable
Silicone Covers
Fig: 3
Knockout Plug
Captive
Drive Box Cover
Screws
Fig: 4
Pendant
Silicone Covers