Using The Remote Control; Maintenance - Prem-I-Air EH1412 Manual

appliance is operating until the number of hours' delay
required before switching off is shown in the display.
To select timed turn-on press the timer SET button when the
appliance is connected to the mains supply but switched off
by the 1/0 button. Press the SET button repeatedly until the
number of hours' delay required before switching on is shown
in the display.
To cancel the timer press the timer RESET button.
A second after pressing the timer controls, the display reverts
to showing the set temperature.

USING THE REMOTE CONTROL

The operating modes are selected in exactly the same way
as using the control panel on the main appliance. To operate
the remote control, make sure that it control is pointed at the
window in the front panel labelled "REMOTE".

MAINTENANCE

Before cleaning, turn the appliance off using the button on
the control panel (NEVER switch off the power at the mains
socket whilst the appliance is running). Wait until the
appliance stop and then disconnect from the mains supply.
The case may then be cleaned using a damp cloth with a
drop of washing-up liquid to remove any dust or dirt from the
case. Do no use stronger detergents or solvents as these
may damage the plastic.
Using a dry 1" (25mm) paint-brush, remove any dust from the
grilles.
Every two weeks, clean the air filter − the filter is located at
the back of the appliance towards the top. Remove the filter,
and wash with hand-hot water with a drop of detergent. Dry
thoroughly before replacing.
Using the EH1412 with a blocked filter will severely reduce its
Page 5