Using The Remote Control; Maintenance - Prem-I-Air EH1413 User Manual

USING THE REMOTE CONTROL

The operating modes are selected in exactly the same way
as using the control panel on the main appliance. To operate
the remote control, make sure that it control is pointed at the
window in the front panel labelled "REMOTE".
1. ON/OFF Button
2. MODE Button
3. FAN Speed Button
4. TEMPERATURE CONTROL Button
5. TIMER Setting Button
6. AUTO SWING Button
Before cleaning, turn the appliance off using the button on the control panel
(NEVER switch off the power at the mains socket whilst the appliance is running).
Wait until the appliance stop and then disconnect from the mains supply. The
case may then be cleaned using a damp cloth with a drop of washing-up liquid to
remove any dust or dirt from the case. Do no use stronger detergents or solvents
as these may damage the plastic.
Using a dry 1" (25 mm) paint-brush, remove any dust from the grilles.
Every two weeks, clean the air filter; the filter is located at the back of the
appliance towards the top. Remove the filter, and wash with hand-hot water with
a drop of detergent. Dry thoroughly before replacing.
Using the EH1413 with a blocked filter will severely reduce its efficiency, and
using without the filter may lead to a build-up of a dust on the heat exchangers,
which may constitute a fire hazard.
If the mains lead is damaged, it must be replaced by the manufacturer or an
authorised service centre. If the mains plug needs to be replaced, proceed as
follows:
positioned correctly (over the outer sheath of the cable) and it fully
tightened.
2836

MAINTENANCE

Connect
•
terminal labelled "L".
Connect the blue wire to the terminal
•
labelled "N"
Connect the green/yellow wire to the
•
terminal labelled with the earth symbol
or "E".
Make sure that the cord-grip is
•
6
the brown wire to the
Ver. 2 - 04/14