Using The Timer - Prem-I-Air EH1412 Manual

INSTALLATION AND OPERATION
If the remote control is to be used, install two AAA batteries
into the battery compartment, ensuring the correct polarity.
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead
is rated at 13 Amps or more, and that it is fully unwound.
Switch the appliance on at the mains socket.
Press the "1/0" button to start the appliance
Select the mode by pressing the "MODE" button. The
available modes are:
AUTO: Automatic mode: selects the optimum fan speed to
maintain the selected room temperature.
FAN: Fan mode: circulates the air, but does not affect room
temperature or humidity
LO/MED/HI: Selects low, medium or high air flow.
Set the required room temperature using the THERMO
CONTROL buttons. The set temperature is displayed on the
LED display.
AUTO SWING: Selects up and down movement of the
louvres.
If the DRAIN WATER indicator illuminates, place a container
underneath the end of the water drain tube (on the back of
the internal appliance) and remove the bung. Allow the water
to drain out, and then replace the bung.

USING THE TIMER

The timer can set the appliance to run for a selected time
(between 1 and 24 hours) and then turn OFF.
Or, it can set the appliance to wait for a selected time
(between 1 and 24 hours) before turning ON.
To select timed turn-off press the timer SET button whilst the
Page 4