Starting The Brew - Fetco CBS-1261 User Manual

Starting The Brew

1. Turn the power switch "ON". (Twin Shown)
FETCO
2. Prepare a brew basket with the correct size filter and correct amount of coffee.
Ready to Brew
3. Slide the brew basket completely into the rails.
4. Place a clean, empty, and preheated dispenser under the brew basket.
STOP
STOP
5. Select a batch & hold the corresponding BREW button in for 1 second to start
6. -STOP button will illuminate,
-Countdown time will display,
-Selected BREW button will flash to indicate brew is in progress.
-All other BREW buttons for that brew head will extinguish.
7. When the brew cycle is finished,
STOP button will extinguish and the BREW button will continue to flash for the
amount of time programmed into the DRIP DELAY setting.
This indicates that coffee may still be dripping from the brew basket
For safety- do not remove brew basket until drip-out is complete.
Twin Brewer ready to brew. Example shown: Pressing top right brew position
RECIPE Location map
Viewing and changing settings for the brew
recipes is from the "A" screens with the controls in
PROGRAMMING.
The uppermost button positions are permanent
and will not display programming step A_0. The
table above shows in position A20 that a button
position can be made active or inactive.
Position A1 does not display this step
The "A" menu is the most accessed menu. It is for programming the batch volumes, brewing parameters, enabling or
disabling brew buttons. The "A" menu moves through the six positions(CBS-1262-) or three positions(CBS-1261+) by
entering the menu and pressing the left stop button. (only the left side is active for programming the CBS-1262+)
The A menus [A1-3 or A1-6] correspond to batch buttons [3 or 6] on the touch panel
Access the A menus to PROGRAM & make changes to individual menu recipes. Menu settings can be copied
Menu positions A1 and A4 [top position] are permanent. Menus A2, A3, A5, A6 can be removed by operator if desired
Batch Program
A1
STOP
STOP
From A PRG screen
Press button 1 to go
into to the A menu
access screens.
Continue pressing
button #1 to enter
programming for A1
Go to fetco.com for the latest versions of all information
Brew Volume
Batch Enabled
A1.10 3.80L +/-
A2.00
STOP
STOP
From A11 screen From A20 screen
Press STOP to Press STOP to
scroll to A20. scroll through the
(A1&A4 are permanent)
remaining (3 or 6)
"A" menus. Make
any changes as
required
Single Side Models
DISPLAY
CBS-1261 Plus
STOP
STOP
BATCH A1
(permanent)
BATCH A2
(enabled by factory)
BATCH A3
(disabled by factory)
Batch Enabled
A6.00
YES -
STOP
STOP
STOP
From A60 screen
Scroll out to
remaining A10-to
A70 programming
keys. See SAVE &
EXIT in previous
table
User Guide & Operator instructions
Page 5
Ready
STOP
Brewing-see #6 above
Dual Side Models
DISPLAY
CBS-1262 Plus
STOP STOP
STOP
BATCH A4
(permanent)
BATCH A5
(enabled by factory)
BATCH A6
(disabled by factory)
(Dual model shown)
Batches A1 to A6
NO+
STOP STOP STOP
A1
A2
A3
For single and twin
Position of batch
buttons for CBS-1252+
The CBS-1251+ single
position brewer has
one row of buttons
P214 September 2023
Brewing
7:30
STOP
A4
A5
A6