Notices; Radio Frequency Interference (Rfi) (Fcc 15.105); Labeling Requirements (Fcc 15.19); Modifications (Fcc 15.21) - Comtrol DEVICE MASTER RTS Hardware Installation And Configuration

Table of Contents

Advertisement

Notices

Radio Frequency
Interference (RFI)
(FCC 15.105)
Labeling
Requirements (FCC
15.19)
Modifications (FCC
15.21)
Serial Cables (FCC
15.27)
Underwriters
Laboratory
Important Safety
Information
Warning
This equipment has been tested and found to comply with the limits for Class A
digital devices pursuant to Part 15 of the FCC Rules.
This equipment generates, uses, and can radiate radio frequency energy, and if
not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with part 15 of FCC rules. Operation is subject to the
following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications to this equipment not expressly approved by Comtrol
Corporation may void the user's authority to operate this equipment.
This equipment is certified for Class A operation when used with unshielded
cables.
This equipment is Underwriters Laboratory "UL" listed.
To avoid contact with electrical current:
Never install electrical wiring during an electrical storm.
Never install the power plug in wet locations.
Use a screwdriver and other tools with insulated handles.
Notices
25

Advertisement

Table of Contents
loading

Table of Contents