7. Install the
M.2 solid-state
8. Install the
base
cover.
9. Install the
SD
card.
10. Follow the procedure in
Wireless Local Area Network (WLAN) Antennas
Removing the WLAN antenna module
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the
M.2 solid-state
5. Remove the
VPU
card, for systems shipped with a VPU card.
6. Remove the Battery.
7. Remove the
left
fan.
8. Remove the
right
fan.
9. Remove the heatsink.
10. Remove the
system
board.
About this task
CAUTION:
The information in this removal section is intended for authorized service technicians only.
NOTE:
The following procedure is applicable for systems shipped with WLAN antennas only.
The following images indicate the location of the WLAN antenna module and provide a visual representation of the removal
procedure.
drive, for systems shipped with a solid-state drive.
After working inside your
Before working inside your
drive, for systems shipped with a solid-state drive.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
Before working inside your
109