Installing The M.2 2230 Solid-State Drive - Dell NOT22422 Owner's Manual

Steps
1. Remove the single (M2x2) screw that secures the solid-state drive thermal plate in place.
2. Remove the solid-state drive thermal plate from the system board.
3. Remove the M.2 2230 solid-state drive with the solid-state drive bracket from the system board.
4. Remove the single (M2x2) screw that secures the M.2 2230 solid-state drive to the solid-state drive bracket.
5. Remove the M.2 2230 solid-state drive from the solid-state drive bracket.

Installing the M.2 2230 solid-state drive

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
CAUTION: The information in this installation section is intended for authorized service technicians only.
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
46 Removing and installing Field Replaceable Units (FRUs)