Spindle Lubrication System - Okuma VTM-200 Operation & Maintenance Manual

2-3.

Spindle Lubrication System

Oil level gauge
Oil Specification (ISO)
Amount
Oil Change Interval
When the machine is operated at a high "utilization" rate, special care should be exercised as to
cleanliness and the condition of the oil used. If the oil is dirty, oil change must be made more fre-
quently than specified in the above table.
All the spindle bearings are lubricated by packed high quality grease, requiring no further greasing.
SECTION 4 INSPECTION, MAINTENANCE AND ADJUSTMENTS
Pressure switch
Oil filter
Oil Pump
Suction filter
Oil Pump
Oil filler port
Oil filter
Drain port
Change after the first 3 months of operation and thereafter
every 6 months.
Headstock Headstock Headstock
Fan cooler
Fan cooler
Pressure switch
Suction filter
CKB32
19 L (5.0 gal)
5699-E P-54
LE11214R0100600070001