Precautions For Cleaning The Safety Window - Okuma VTM-200 Operation & Maintenance Manual

5699-E P-49
SECTION 4 INSPECTION, MAINTENANCE AND ADJUSTMENTS
In addition to the above periodical inspections, there are inspection and maintenance items which
should be carried out whenever necessary. Since they are described later in this manual, carry them
out without failure.
* Clean the magazine rail, ready station, and tool change arm whenever necessary.
However, avoid using compressed air to blow chips off, because chips enter inside of these units.
1-1.

Precautions for Cleaning the Safety Window

(1) Use a soft cloth for cleaning. Do not use a scourer or hard cloth.
(2) Use water or warm water when removing dirt. If it is difficult to remove dirt, use a neutral deter-
gent (for example, a kitchen detergent) by diluting it.
(3) Do not use organic solvents, such as thinner and benzene, or strong alkali detergents.