Table of Contents
Advertisement
3.4.2 Mounting Dimensions
Refer to Honeywell drawing number 50049930 (Dual Head), 50049931 (In-Line), 50049932 (Flange
Mount) 50049933 (Extended Flange), and 50049934 (Remote Seal) for detailed dimensions. Abbreviated
overall dimensions are also shown on the Specification Sheets for the transmitter models. This section
assumes that the mounting dimensions have already been taken into account and the mounting area can
accommodate the transmitter.
3.4.3 Bracket Mounting Procedure
If you are using an optional bracket, start with Step 1. For an existing bracket, start with Step 2.
1. Refer to
Figure 5.
install a "U" bolt around the pipe and through the holes in the bracket. Secure the bracket with the
nuts and lock washers provided.
2. Align the appropriate mounting holes in the transmitter with the holes in the bracket. Use the
bolts and washers provided to secure the transmitter to the bracket; see the following variations.
DP with double-ended process heads
and/or remote seals
In-line GP and AP (STG xxL and STA
xxL)
Dual-head GP and AP
Example: Inline model mounted to an optional angle bracket, See
9
Position the bracket on a 2-inch (50.8 mm) horizontal or vertical pipe and
Lockwashers
Mounting
Horizontal Pipe
U-Bolt
Figure 5 – Angle Mounting Bracket Secured to a Horizontal or Vertical Pipe
Transmitter Type
ST 800 Pressure Transmitter User's Manual
U-Bolt
Use Hardware
Alternate mounting holes in the ends of the
heads.
The smaller "U" bolt provided to attach the
meter body to the bracket. See the following
example.
Mounting holes in the end of the process head.
Lockwashers
Mounting
Figure 6.
Revision 15
Advertisement
Table of Contents
