Mounting Dimensions; Bracket Mounting Procedure; Figure 5 - Pipe Mounting Bracket Secured To A Horizontal Or Vertical Pipe - Honeywell stt850 SMARTLINE User Manual

3.1.2 Mounting Dimensions

Refer to Honeywell drawing number 50094836 for detailed dimensions of the transmitter assembly.
Abbreviated overall dimensions are also shown on the Specification Sheets for the transmitter
models. This section assumes that the mounting dimensions have already been taken into account and
the mounting area can accommodate the Transmitter.
Refer to Honeywell drawing numbers 50095917 (Pipe Mount) and 50095918 (Wall Mount) for
detailed mounting specifications.

3.1.3 Bracket Mounting Procedure

1. Align the two mounting holes in the transmitter with the two slots in the mounting bracket
and assemble the (2) M8 hex cap screws, (2) lockwashers and (2) flat washers provided.
Rotate transmitter assembly to the desired position and torque the M8 hex cap screws to 27,0
Nm/20,0 Lb-ft maximum.
2. Pipe Mount Option: Refer to
or vertical pipe, and install a "U" bolt around the pipe and through the holes in the bracket.
Secure the bracket with the nuts, flat washers and lock washers provided.
3. Wall Mount Option: Position the bracket on the mounting surface at the desired location and
secure the bracket to the mounting surface using the appropriate hardware (Wall mounting
hardware requirements to be determined and supplied by the end user).
Figure 5 – Pipe Mounting Bracket Secured to a Horizontal or Vertical Pipe
Revision 3
Figure 5. Position the bracket on a 2-inch (50.8 mm) horizontal
HORIZONTAL PIPE
STT850 Temperature Transmitter User's Manual
VERTICAL PIPE
Page 9