3.6.2
IAR EWARM
This section provides steps to beginners on how to run a project by using IAR EWARM.
1. Double click the "Template.eww" to open the project.
2. Make sure the toolbar contain "Nu-Link" item as shown in Figure 3-15.
Note: If the toolbar does not contain "Nu-Link" item, please rework section 3.2.
3. Make target file as presented in Figure 3-16. After successfully compile the project, download
code to the flash memory and enter debug mode.
2
Feb.
20, 2019
Figure 3-15 IAR EWARM Window
1. Make
2. Successfully compile
3. Download and Debug
Figure 3-16 Compile and Download the Project
Page 31 of 37
NuMaker-M031SD
1
3
Rev 1.00