3.5
Find the Example Project
Use the "Template" project as an example. The project can be found under the BSP folder as shown
in Figure 3-7.
M031_Series_BSP_CMSIS_V3.XX.XXX
SampleCode
Template
GCC
Keil
IAR
3.6
Execute the Project under Toolchains
Open and execute the project under the toolchain. The section 3.6.1, 3.6.2, and 3.6.3 describe the
steps of executing project in Keil MDK, IAR EWARM and NuEclipse, respectively.
3.6.1
Keil MDK
This section provides steps to beginners on how to run a project by using Keil MDK.
1. Double click the "Template.uvproj" to open the project.
Note: If Figure 3-8 warning message jumps out, please migrate to version 5 formats as shown in
Figure 3-9. The ".uvproj" filename extension will change to ".uvprojx".
Figure 3-8 Warning Message of "Device not found"
Feb.
20, 2019
Figure 3-7 Template Project Folder Path
Page 27 of 37
NuMaker-M031SD
Rev 1.00