Table of Contents
Advertisement
BEFORE OPERATION
POWER
MICLEAR
To turn the unit on
Press the POWER button.
The disc compartment may open and close to reset the unit.
DEMO (Demonstration) mode
After connecting the AC cord, the display window demonstrates
the functions of the unit. When the power is turned on, the DEMO
display is overridden by the operation display. When the power
is turned off, the DEMO mode is restored.
To cancel DEMO mode
Press the DEMO button. To re-activate, press again.
Flash window
The window on the top of the unit lights up or flashes while the
unit is being powered on.
To turn off the light, press the Il CLEAR button on the main unit
while pressing the CD button. To turn back on, repeat the above.
¢ This operation does not function during recording.
After use
Press the POWER
button to turn off the power. The display
changes to clock.
SETTING THE CLOCK
CLOCK
+L SHIFT
Set the time as follows while the power is off.
1 Press the Il SET button.
The hour flashes.
2 Press the Kd
DOWN
or PPI
UP button to
designate the hour.
3 Press the Il SET button to set the hour.
The hour stops flashing and the minute starts flashing.
4 Press the ké< DOWN
or PPI UP button to
designate the minute.
5 Press the If SET button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 second.
To correct the current time
Press the POWER button to turn the unit off. Press the I SET
button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control. The clock is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button while pressing the SHIFT button on
the remote control and then press the CLEAR button within 4
seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption.
The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
Advertisement
Table of Contents
