Errors And Trouble Shooting - HOMCOM A90-246 User Manual

How to add lubricant
Please adhere to the following instructions carefully.
Open the side bar on the front left of the refuelling decorative cover. Insert
the bottle into the opening to measure the size, use a pair of scissors or art
knife to cut off tip of the bottle to size. Place the bottle into the hole and
squeeze the bottle (as illustrated to refuel). Please ensure the oil bottle tip
of the thin rod is inserted correctly and securely into the fuel pipe on the
platform and then pour oil into it.
8.

ERRORS AND TROUBLE SHOOTING

8.1. The electronic table displays the error message code and excludes:
FAULT CODE
Communication anomalies:
power-on control and electronic
E1
table communication aabnormal.
E2
High voltage fault
E3 No motor detected
E5 Over current protection: In the
operational state, the control
continuously detects that the DC
motor current is greater than the
amount of fixed current, up to 3
seconds
E6
Explosion protection: abnormal
supply voltage or motor anomalies,
etc. lead to drive motor circuitry
damage.
E07 Safety switch not on.
ISSUE
Possible causes: electronic control and electronic table
communication is blocked, check the electronic table to the next
section of the control communication line of the connection, to
ensure that each core is fully inserted. Check if the electronic
table is connected to the controller break, replace the cable.
Check the motor line for damage, odour, replace the motor.
Check that the motor line is connected and reconnect the motor
line. Check the motor line for damage, odor, replace the motor.
Possible reasons: more than the rated load caused by excessive
current, system self-preservation, or a part of the treadmill is
stuck dead, resulting in the motor cannot turn, the load is too
heavy, the current is too large, the system self-insurance; There
is also checking the motor for over current or burning odor,
replacing the motor, checking the controller for burning air,
replacing the controller, or checking that the supply voltage
specifications are not high or low, retest using the correct voltage
specifications.
Possible cause: Check if the supply voltage is below normal.
50%, retest with the correct voltage specifications, check the
controller for odour, replace the controller, check that the motor
line is connected, and reconnect the motor line.
SOLUTION
Put the security lock in place.
~ 10 ~