Table of Contents
Advertisement
7700 Multi-Frame Manual
7707MT-HD Multi-Signal HD/SD, AES, and Control Fiber Transmitter
2.
INSTALLATION
Each 7707MT-HD module comes with a companion rear plate that has two BNC connectors, a multi-pin
removable terminal block, and an SC/PC (shown), ST/PC or FC/PC optical connector. For information on
mounting the rear plate and inserting the module into the frame see section 3 of the 7700FR chapter. The
following diagram shows single-fiber and dual-fiber rear plate options.
2.1.
ELECTRICAL SIGNAL CONNECTIONS
HD INPUT:
Input BNC connector for serial digital video signals compatible with HD-SDI (SMPTE
292M), SD-SDI (SMPTE 259M-C), and SDTi (SMPTE 305.2M) standards. This input
provides adaptive equalization for up to 100m of industry standard Belden 1694A cable, at
1.485Gb/s. At 270Mb/s, this input provides adaptive equalization for up to 300m of Belden
1694A cable. See section 3.1 for video input specifications.
Page-4
7707MT-HD-F2
7707MT-HD
Figure 2-1: 7707MT-HD Rear Plates & Pin Out
Pinout Detail
Version 1.5
A1+
A2+
A1-
A2-
GND
GND
A3+
A4+
A3-
A4-
GPI
GPO
DO+
DI+
DI-
DO-
Advertisement
Table of Contents
