Advertisement
TRIPOD MOUNTING
28
These holes cannot be used.
Lock lever
(Tripod base release)
Cy
———~.
—~
ee
E>
l
aan =
mn =
I
—
The KA-510 Tripod Base included with the camera must be
used to secure the camera to a tripod or camera stand.
1. Tripod mounting holes
Match a 3/8 or 1/4 inch tripod mounting screw to the best
hole for good balance.
2. Tripod mount release
Pull back once to activate the front clip before mounting the
camera.
Ac & Safety lever
Prevents accidental release. If the camera is secured in the
Base, this release lever must be pushed in order to pull the
release lever and open the Base.
4. Rear mounting pin
Make sure the rear mounting clip of the camera is firmly on
the Tripod Base, so that the rear mounting pin can be en-
gaged properly.
5. Front mounting clip
Making sure the rear mounting pin engages, slide the front
mounting wedge on the camera into the front mounting clip
of the base until it engages automatically with a clik.
The front clip will hold the camera safely, but without engag-
ing the rear clip, the camera will tend to move slightly in the
Base.
6. Mounting error
Double check that the rear pin is engaged properly.
The front clip will hold the camera safely, but without engag-
ing the rear clip, the camera will tend to move slightly in the
Base.
Advertisement
