Advertisement
1. Scope
This document specifies the procedures of mating / unmating operation for
DF57H-＊S-1.2C and DF57H-＊P-1.2V (＊: Number of position).
2. Part Number
Part No.
DF57H-＊S-1.2C
DF57H-＊P-1.2V
DF57-####SCF
DF57H-2S-1.2C
+DF57-####SCF (With cable)
3. Operation Procedures
3-1. Mating
3-1-a. Alignment for Mating
: By positioning the convexity of the socket sides to the header concavity, align
the centers of the socket and the header in pitch direction.
COUNT
DESCRIPTION OF REVISIONS
△
1
3
TITLE
DF57H Series Mating / Unmating Operation Instruction Manual
TECHNICAL SPECIFICATION
FORM HC0011-9-1
Description
Socket
Header
Crimp contact
Fig. 1: DF57H Connector
Pitch direction
Fig. 2: Alignment for mating
DIS-H-00014677
DF57H-2P-1.2V
DESIGNED
HK.HAYASHI
HIROSE ELECTRIC CO.,LTD.
APPROVED
CHECKED
DESIGNED
WRITTEN
ETAD-H0652
CHECKED
DATE
SZ.ONO
20220725
KI.AKIYAMA
20120622
HK.UMEHARA
20120622
TS.KUMAZAWA
20120621
TS.KUMAZAWA
20120621
1 / 4
△
1
Advertisement
Table of Contents
Related Manuals for HRS DF57H S-1.2C Series
Summary of Contents for HRS DF57H S-1.2C Series
- Page 1 1. Scope This document specifies the procedures of mating / unmating operation for DF57H-＊S-1.2C and DF57H-＊P-1.2V (＊: Number of position). 2. Part Number Part No. Description Socket DF57H-＊S-1.2C Header DF57H-＊P-1.2V DF57-####SCF Crimp contact DF57H-2S-1.2C +DF57-####SCF (With cable) DF57H-2P-1.2V Fig. 1: DF57H Connector 3.
- Page 2 3-1-b. Temporary Insertion : Slightly press the socket down at cable side to tilted angle. Cable side Lever side Crimp socket Insertion direction Header Fig. 3: Temporary insertion If the crimp socket is pushed down horizontally without temporary insertion as shown above, the lock structure could be damaged, and lock strength could be lowered.
- Page 3 3-1-d. Mating Confirmation : Make sure that the socket is completely mated. If one side is floating or not completely mated, remove the socket from the header and insert again. Refer to 3-2. for removal operation. Correct image of mated connector Fig.
- Page 4 Make sure to use the lever for removal operation. If the cable is pull for removal, it could break the cable or damage the connector. Fig. 9: Incorrect removal operation 4. Precautions -Do not operate the connector while the electricity is carried. -If excessive force is applied to the connector, failure or damage could be caused.
Need help?
Do you have a question about the DF57H S-1.2C Series and is the answer not in the manual?
Questions and answers