Verizon FSNO21VA User Manual page 181

08 / NOTICES
181
RF Exposure:
To comply with FCC RF exposure compliance requirements, the
antenna used for this transmitter must be installed to provide a
separation distance of at least 28cm from all persons (indoor), and
must not be co-located or operating in conjunction with any other
antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
8.0b/ NEbS (Network Equipment building System) Statement
An external SPD is intended to be used with FSNO21VA.
WARNING: WARNING: The intra-building ports of the equipment or
subassembly is suitable for connection to intra-building or
unexposed wiring or cabling only. The intra-building port(s) of the
equipment or subassembly MUST NOT be metallically connected to
interfaces that connect to the OSP or its wiring. These interfaces
are designed for use as intra-building interfaces only (Type 4 ports
as described in GR-1089) and require isolation from the exposed
OSP cabling. The addition of Primary Protectors is not sufficient
protection in order to connect these interfaces metallically to OSP
wiring.
http://setup.verizon.com/businessinternetgateway | ©2023 Verizon. All Rights Reserved