Operating Instructions; Starting And Stopping - Toro REELMASTER 6700-D Operator's Manual

Operating Instructions

Before servicing or making adjustments to the machine, stop
the engine and remove the key from the switch.

STARTING AND STOPPING

1. Sit on the seat; keep your foot off the traction pedal.
Assure the parking brake is engaged, the traction pedal is in
NEUTRAL, the throttle is in the SLOW position and the
ENABLE/ DISABLE switch is in the DISABLE position.
The engine will not crank over until the glow plug lamp
goes out. Glow plugs must complete their cycle before
the controller will allow the engine to crank.
2. Turn the ignition switch to ON/Preheat position. An auto-
matic timer will control preheat for approximately 6 sec-
onds. The engine will not crank until preheat light goes
off. After preheat, turn the key to START position. CRANK
THE ENGINE FOR NO LONGER THAN 15 SECONDS.
Release the key when the engine starts. If additional preheat
is required, turn the key to the OFF position, then to
ON/preheat position. Repeat this process as required.
3. Run the engine at idle speed or partial throttle until the
engine warms up.
CAUTION
WARNING
Figure 14
1. Seat adjusting lever
2. Seat adjusting knob
17