Toro REELMASTER 6700-D Operator's Manual page 39

connector from the alternator to prevent damage to the elec-
trical system.
Wear safety goggles and rubber gloves when working with
electrolyte. Charge the battery in a well ventilated space so
gases produced while charging can dissipate. Since the gases
are explosive, keep open flames and electrical sparks away
from the battery; do not smoke. Nausea may result if the gases
are inhaled. Unplug the charger from the electrical outlet
before connecting or disconnecting charger leads to or from
battery posts.
Note: Check battery condition weekly or after every 50 hours of
operation. Keep terminals and the entire battery case clean
because a dirty battery will discharge slowly. To clean the bat-
tery, wash the entire case with solution of baking soda and
water. Rinse with clear water. Coat the battery posts and cable
connectors with Grafo 112X grease (Toro Part No. 505-47) or
petroleum jelly to prevent corrosion.
FUSES
There are 7 fuses in the machine's electrical system. They are
located below the control panel.
CAUTION
Figure 49
1. Fuses
IMPORTANT
USE CORRECT FUSES.
WRONG FUSES CAN CAUSE
DAMAGE TO CONTROLLER AND
VOID WARRANTY.
CONTROLLER
LOGIC
2A
ACCESSORY
POWER
7.5A
OPTIONAL
LIGHTS
10A
CONTROLLER
POWER (2)
15A
CONTROLLER
POWER (1)
10A
IGNITION
SWITCH
20A
CONTROLLER
POWER (1)
10A
CONTROLLER
POWER (1)
10A
94-6348
39