Toro REELMASTER 6700-D Operator's Manual page 36

units, stop the engine, engage the parking brakes and
remove the key from the ignition switch.
2. Clean the area around the filter mounting area. Place the
drain pan under the filter and remove the filter.
3. Lubricate the new filter gasket and fill the filter with
hydraulic fluid.
4. Assure the filter mounting area is clean. Screw the filter
on until gasket contacts mounting plate. Then tighten the
filter one-half turn.
5. Start the engine and let it run for about two minutes to
purge air from the system. Stop the engine and check for
leaks.
CHECKING HYDRAULIC LINES AND
HOSES
Inspect hydraulic lines and hoses daily for leaks, kinked lines,
loose mounting supports, wear, loose fittings, weather deterio-
ration and chemical deterioration. Make all necessary repairs
before operating.
WARNING
Keep your body and hands away from pin-hole leaks or
nozzles that eject high-pressure hydraulic fluid. Use card-
board or paper to find hydraulic leaks. Hydraulic fluid
escaping under pressure can penetrate skin and cause injury.
Fluid accidentally injected into the skin must be surgically
removed within a few hours by a doctor familiar with this
form of injury or gangrene may result.
ADJUSTING THE TRACTION DRIVE
FOR NEUTRAL (Fig. 44)
The machine must not creep when the traction pedal is
released. If it does creep, an adjustment is required.
1. Park the machine on a level surface, shut the engine off
and lower cutting units to the floor. Depress only the
right brake pedal and engage the parking brake.
2. Jack up the left side of the machine until front tire is off
the shop floor. Support the machine with the jack stands
to prevent it from falling accidentally.
Note: On 4-wheel drive models, the left rear tire must
also be off the shop floor.
36
Figure 44
1. Pump rod
2. Pump control tube