Toro REELMASTER 6700-D Operator's Manual page 16

Engine Coolant Temperature Warning Light (Fig.10 )—
The light illuminates and the engine shuts down when coolant
reaches a dangerously high temperature.
Glow Plug Indicator Light (Fig. 10)—When lit, indicates the
glow plugs are on.
Charge Indicator (Fig. 10)—Illuminates when the system
charging circuit malfunctions.
Enable/Disable Switches (Fig. 10)—Used with lower mow /
raise control lever to operate the reels.
Water-in-the-Fuel Light (Fig. 10)—Warns of water in the
fuel system.
Low Water Level Light (Fig. 10)—Warns that the coolant
water level is low.
Height-of-Cut Selector Knob (Fig. 11)—Turning the knob to
the appropriate setting informs the electronic controller at
what height-of-cut the machine is being operated so desired
clip may be obtained. See section in manual for operating
instructions. The knob is located under the control panel.
Hour Meter (Fig. 12)—Shows total hours the machine has
been operated.
Backlap Switch (Fig. 13)—Used with the lower mow / raise
control lever for backlapping operation. This switch is located
under seat plate. Refer to Cutting Unit Maintenance,
Backlapping.
Seat (Fig. 14)—Seat adjusting lever allows 10 cm fore and aft
adjustment. Seat adjusting knob adjusts seat for operator's
weight. To adjust the seat fore and aft, pull the lever on the
left side of the seat assembly outward. After moving the seat,
release the lever to lock the seat into position. To adjust for
operator's weight, turn the spring tension knob: clockwise to
increase tension, counterclockwise to decrease spring tension
16
Figure 11
1. Height-of-cut selector knob
1
Figure 12
1. Hour meter
Figure 13
1. Backlap switch
1
1