Toro REELMASTER 6700-D Operator's Manual page 38

6. When all oil has drained, re-install the plug in the hub.
7. Add high-quality SAE 85W-140 wt. gear lubrication to
bring the level up to the bottom of the hole and install the
plug.
8. Repeat this procedure on the opposite gear assembly.
CHANGING REAR AXLE LUBRICANT
After every 800 hours of operation, the oil in the rear axle
must be changed.
1. Position the machine on a level surface.
2. Clean the area around the (3) drain plugs, (1) on each end
and (1) in the center.
3. Remove check plugs to ease draining of oil.
4. Remove drain plugs and drain oil into pans.
5. After the oil has drained, apply thread sealing com-
pound on the drain plug threads and reinstall them in
the axle.
6. Remove a check plug and fill axle with approximately 80
oz. of 85W-140 weight gear lube or until lubricant is up
to the bottom of the hole.
REAR WHEEL TOE-IN
After every 800 operating hours or annually, check rear wheel
toe-in.
1. Measure center-to-center distance (at axle height) at front
and rear of steering tires. Front measurement must be 1/4
in. less than rear measurement.
2. To adjust, loosen clamps at both ends of tie rods.
3. Rotate tie rod to move front of tire inward or outward.
4. Tighten tie rod clamps when adjustment is correct.
BATTERY CARE
IMPORTANT. Before welding on the machine, disconnect
both cables from the battery, disconnect both wire harness
plugs from the electronic control unit and the terminal
38
Figure 46
1. Drain/Check plug
Figure 47
1. Drain plug location
Figure 48
1. Drain plugs (3)