Toro REELMASTER 6700-D Operator's Manual page 12

Chevron
BP Oil
Boron OIl
Exxon
Conoco
Kendall
Phillips
Note: The fluids within this group are interchangeable.
Group 2 Hydraulic Fluid (Biodegradable):
ISO VG 32/46 anti-wear hydraulic fluid
Mobil
Note: The fluid in this group is not compatible with the
fluids in group 1.
IMPORTANT: These hydraulic fluids are specified to allow
optimal operation of the machine in a wide range of tem-
peratures encountered. The group 1 fluids are a multi-vis-
cosity hydraulic fluids which allows operation at lower
temperatures without the increased viscosity, which is asso-
ciated with straight viscosity fluids.
Note: When changing from one type of hydraulic fluid to the
other, be certain to remove all the old fluid from the sys-
tem, because some brands of one type are not completely
compatible with some brands of the other type of
hydraulic fluid.
IMPORTANT: Use only types of hydraulic fluids specified.
Other fluids could cause system damage.
Note: A red dye additive for the hydraulic system fluid is
available in 20 ml bottles. One bottle is sufficient for
15–23 l. of hydraulic fluid. Order Part No. 44-2500 from
your Authorized Toro Distributor
1. Position the machine on a level surface, lower the cutting
units and stop the engine.
2. Clean the area around the filler neck and the cap of the
hydraulic tank. Remove the cap from the filler neck.
3. Remove the dipstick from the filler neck and wipe it with
a clean cloth. Insert the dipstick into the filler neck; then
remove it and check the level of fluid. Fluid level should
be within 0.6 cm of the mark on the dipstick.
4. If the level is low, add fluid to raise the level to the full
mark.
5. Install the dipstick and cap onto the filler neck.
12
Tractor Hydraulic Fluid
BP HYD TF
Eldoran UTH
Torque Fluid
Power-Tran 3
Hyken 052
HG Fluid
EAL 224 H