Table of Contents
Advertisement
2.
Remove the check plug from the side of the gear box (Fig 15)
and make sure the lubricant is up to the bottom of the hole. If
the level of lubricant is low, remove the fill plug on top of the
gear case and add enough lubricant to bring it up to the bottom
of the hole in the side
Operating Instructions
ADJUSTING HEIGHT OF CUT
The height of cut is adjustable from 25 to 102 mm in 13 mm incre-
ments, by adding or removing an equal number of spacers on the
front and rear caster forks. The height-of-cut chart below gives the
combinations of spacers to use for all height-of-cut settings.
Note: 6 mm spacers are available and can be ordered from your
Toro distributor by Toro Part No. 27-1040. (Quantity-8).
Height-of-Cut Setting
25 mm
38 mm
51 mm
64 mm
76 mm
89 mm
102 mm
Note: A more optimum cutting appearance of the turf can be
achieved in the lower heights of cut by lowering the rear of the cut-
ting unit. Accomplish this by relocating the rear caster wheel axles
in the upper hole of the caster forks (Fig. 3). Replace the axles into
the lower caster fork holes for higher height-of-cut settings where
optimum cutting appearance is not required.
IMPORTANT: Do not attempt to cut off more than 25 mm of
10
Spacers Below Caster Arm
Front
Rear
0
1
2
3
4
5
6
1.
Filler plug
1.
lynchg pin
2.
Large front castor
0
1
2
3
4
5
6
1.
lynchg pin
2.
Small (rear caster)
3.
Spacers
4.
Washer
5.
For 25 mm height of cut only
Figure 1
2. Check plug
Figure 2
3. Spacers
4. Washer
Figure 3
Advertisement
Table of Contents
