Place The Thor Vm1 W In The Dock; Removing The Thor Vm1 W From The Dock - Honeywell Thor VM1 W User Manual

Place the Thor VM1 W in the Dock

1. Locate the lip on the top rear of the Thor VM1 W.
2. Slide this lip over the top of the Dock. Slide the Thor VM1 W from side to side on the Dock to make sure it fully engages
on the lip of the Dock. If the Thor VM1 W cannot be slid side to side, the lip is engaged.
3. Pull the quick release lever on the Thor VM1 W down and push the Thor VM1 W against the Dock.
4. Release the quick release lever.
5. If necessary, use the supplied RAM wrench to adjust the viewing angle of the Thor VM1 W.

Removing the Thor VM1 W from the Dock

The Thor VM1 W may be removed from the Quick Mount for limited periods of use or the transfer from vehicle to vehicle.
The UPS battery inside the Thor VM1 W powers a fully functional Thor VM1 W for a minimum of 30 minutes.
To remove the Thor VM1 W from the Dock:
1. Pull the release lever downward on the back of the Thor VM1 W.
2. Pull the bottom of the Thor VM1 W away from the Dock.
3. Lift the Thor VM1 W away from the Dock.
1. Notch on Thor VM1 W
2. Lip on dock
3. Release lever
2-3