Connecting An Ac/Dc Power Supply - Honeywell Thor VM1 W User Manual

Connecting an AC/DC Power Supply

Note: The Honeywell-approved AC Power Supply and Adapter Cable are only intended for use in a 25ºC
(77ºF) maximum ambient temperature environment.
In North America, this unit is intended for use with a UL Listed ITE power supply with output rated 12 – 80 VDC, minimum
60W. Outside North America, this unit is intended for use with an IEC certified ITE power supply with output rated 12 – 80
VDC, minimum 60W.
The external power supply may be connected to either a 120V, 60Hz supply or, outside North America, to a 230V, 50Hz
supply, using the appropriate detachable cordset. In all cases, connect to a properly grounded source of supply provided with
maximum 15 Amp overcurrent protection (10 Amp for 230V circuits).
1. Turn the Thor VM1 W off.
2. Connect the detachable cordset provided by Honeywell (US only, all others must provide their own cable) to the
external power supply (IEC 320 connector).
3. Plug cordset into appropriate, grounded, electrical supply receptacle (AC mains).
4. Connect the DC Output Cable end to the power connector on the Thor VM1 W Quick Mount.
5. Turn the Thor VM1 W on.
1. AC Input Cable (US only)
2. DC Output Cable
3. To DC Output Cable (see above)
4. To Thor VM1 W
3-3