Honeywell Thor VM1 W User Manual page 33

Ignition Controlled - Ignition wire must be connected and the Auto-On Feature disabled. When switched vehicle
l
power is available the ignition wire can be connected (less than 1mA over input voltage range) to it to allow the Thor
VM1 W to power on when the vehicle is switched on and go into suspend when the vehicle is switched off.
Auto-On Controlled - The vehicle supply connections should be made to vehicle switched power to allow the terminal
l
to automatically power-up when vehicle power is switched on or when the power switch on the back of the Dock is
placed in the On position. The Ignition wire is not used and should be left disconnected.
Manually Controlled - Ignition wire must be left unconnected and the Auto-On Feature disabled.
l
1. Existing Circuitry on Vehicle
2. Forklift Battery
3. Main Switch
4. 10A Slow blow Fuse close to
power source
5. Ignition
6. Red Wire (DC +)
7. Black Wire (DC -)
8. Green Wire (Ground)
9. Blue Wire (Ignition Signal)
10. Thor VM1 W Computer in
Quick Mount Smart Dock
11. COM1 or COM2 Connector on
Dock
12. Circular Power Connector on
Dock
1. Existing Circuitry on Vehicle
2. Forklift Battery
3. Main Switch
4. 10A Slow blow Fuse close to
power source
5. Red Wire (DC +)
6. Black Wire (DC -)
7. Green Wire (Ground)
8. Blue Wire (not connected)
9. Thor VM1 W Computer in
Quick Mount Smart Dock
10. COM1 or COM2 Connector on
Dock
11. Circular Power Connector on
Dock
3-7