Touchscreen; Apply The Touchscreen Protective Film - Honeywell Thor VM1 W User Manual

Touchscreen

Apply the Touchscreen Protective Film

First, clean the touchscreen
Remove the protective film from its container. Remove any protective backing from the film sheet by lifting the backing from a
corner of the film. Discard the backing.
1. Make sure both the touchscreen and protective film are clean and dry before installation. Please review
Display for instructions on suitable cleaning agents.
2. Center the protective film over the touchscreen. The antiglare side must be facing outward. Do not cut or trim the
protective film.
3. The protective film is approximately 1/10" (2.54cm) larger than the touchscreen at the centers of the edges .
4. Slide the protective film so that one of the edges of the film can be slid between the touchscreen and display housing
when the protective film is re-centered on the touchscreen. Repeat for the other three edges, ensuring the protective film
is centered over the touchscreen when finished.
5. To remove the protective film, slide the protective film in one direction until the edge clears. Lift up on the edge of the
film so it does not slide between the touchscreen and display housing when slid back. Repeat until all edges are free
and remove the protective film.
Contact your representative
of fingerprints, lint particles, dust and smudges.
about protective film packs designed specifically for your Thor VM1 W touchscreen.
Cleaning the
2-15