Advertisement
4.
Operating modes
Hardware installation
Prior to shipment this unit was inspected and found free of mechanical or electrical defects. Upon
unpacking of the unit, inspect for any damage, which may have occurred in transport. The inspection
should confirm that there is no exterior damage to the unit, such as broken knobs or connectors, and that
the panels are not scratched or cracked. Keep all packing material until the inspection has been
completed. If damage is detected, file a claim with carrier immediately and notify CAEN. Before installing
the unit, make sure you have read thoroughly the safety rules and installation requirements, then place
the package content onto your bench; you shall find the following parts:
N803x, DT803x or R803x power supply unit
USB cable
10BASE-T Ethernet cable
Power cord (DT803x and R803x only)
N803x's are housed in a 2-unit NIM mechanics. The unit is an equipment for BUILDING-IN: install it in a
NIM crate providing the required power supplies, with forced cooling air flow, then connect the HV
Channel Output to the load
R803x's are housed in 19" rack package. The unit is an equipment for BUILDING-IN: install it in a 19" EIA
compliant equipment rack. Use the front panel rack-mount brackets to install the unit in the rack, using
standard screws; leave at least one rack unit of free space above and below the unit. Plug the power cord
into the AC Input (see p.11) and then to the mains AC; connect the HV Channel Output to the load.
D803x's are housed in a Desktop package. The unit is an equipment for BUILDING-IN: use it on flat solid
surfaces, such as a table or a desk. Plug the power cord into the AC Input (see p.11) and then to the mains
AC; connect the HV Channel Output to the load.
Unit control can take place either locally, assisted by a 2.8" Touchscreen LCD or remotely, via USB, or
Ethernet.
Unit Power ON
−
N803x: after hardware installation (see above), turn on the NIM crate
−
DT803x, R803x: after hardware installation (see above), turn on the module, via the rear panel
ON/OFF switch
13
CAEN
Electronic Instrumentation
803x Series 8-16 Ch. Programmable HV Power Supplies
Advertisement
