Advertisement
CAEN
Electronic Instrumentation
Module access via VT emulator
The connection can be performed via VT emulators; we suggest using Tera Term
(see https://ttssh2.osdn.jp/index.html.en)
USB
Launch the terminal emulator, select the serial
communication
communication port associated to the module.
Select USB connection and the used port
number; set port as follows
baud rate 9600
Data bits: 8
Parity: none
stop bit: 1
Flow control: none
Launch communication
Type caen then <enter>;
as the communication is established, the Terminal Board Menu will be displayed:
Ethernet Settings
N.B.: Ethernet settings can be updated ONLY with USB connection; type E on the Board menu: the
following screen will open:
Type S to save; the Ethernet Port is now ready to work with the new settings.
803x Series 8-16 Ch. Programmable HV Power Supplies
link
and
set
the
virtual
Ethernet
Launch the terminal emulator, select port number
1470
Please note that line editing must be disabled prior
to Ethernet access (EnableLineMode=off in the
Teraterm.ini configuration file).
Default settings are:
IP address
Subnet mask
Gateway
Launch communication
Type caen then <enter>;
192.168.0.250
255.255.255.0
0.0.0.0
20
Advertisement
