Electrolux TK 5357 F User Manual page 61

Caution! Never operate the dryer without
the heat exchanger.
Cleaning the drum
Caution! Do not use abrasives or steel wool
to clean the drum.
Lime in the water or cleaning agents may
form a barely visible lining on the inside of the
drum. The degree to which the laundry has been
dried is then no longer detected reliably. The laun-
dry is damper than expected when removed from
the dryer.
What to do if ...
Troubleshooting by yourself
1)
Problem
Dryer not connected to mains supply.
Dryer does
not work. Loading door opened.
The Start/Pause button not pressed.
Incorrect programme set.
Fluff filters clogged.
Heat exchanger clogged.
Unsatisfactory
Max. loading exceeded.
drying results.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
Filters not locked in place.
does not close
Err ( Error ) on
Attempt to change parameters after start
5)
of the programme.
the LCD.
Programme selector in Off (Aus) position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis of:
elapsing time
type, volume and dampness of laundry.
5)
on the LCD
Programme
Full water reservoir.
inactive
Drying cycle Small laundry volume./Too dry laundry for
to short selected programme.
Fluff filters clogged.
Drying cycle
To high loading volume.
6)
to long
Laundry insufficiently spun.
Possible cause
Use a standard domestic cleaner (e.g. vinegar-
based cleaner) to wipe down the inside of the drum
and drum ribs.
Clean operating screen and housing
Caution! Do not use furniture cleaners or
aggressive cleaning agents to clean the
machine.
Use a damp cloth to wipe down the operating
screen and housing.
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Close loading door
Press the Start/Pause button.
Set suitable programme.
Clean fluff filters.
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course filter
into place.
Turn the dryer off and on. Set requested
parameters.
Turn it to Drum light (Beleuchtung) (if
available) or to any programme.
Replace light bulb (see next section).
Automatic process; this is not a machine
fault.
Empty water reservoir
Pause button.
Select time programme or higher drying
level (e.g. Extra dry (Extratrocken) ).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
electrolux 61
Remedy
2)
3)
3)
4)
.
3)
, press Start/