Mitsubishi Electric FR-A520-0.4K-NA Instruction Manual page 214

Name
PG follower (Note 4)
Master controller (Note 4)
Soft starter (Note 4)
Deviation detector (Note 4)
Preamplifier (Note 4)
Pilot generator (Note 4)
Deviation sensor (Note 4)
Frequency setting
potentiometer (Note 4)
Frequency meter (Note 4)
Calibration resistor (Note 4)
Inverter setup software
Note: 1. "H" in the type code indicates 400V class.Power supply specifications of FR series controllers
and setters: 200VAC 50Hz, 200V/220VAC 60Hz, 115VAC 60Hz.
2. Rated power consumption
3. The intercompatibility attachment (FR-A5AT
exception of some models.
4. Options available in Japan only.
Type
For follow-up operation using the signal of a pilot
FR-FP
generator (PG). (2VA)
For parallel operation of several (up to 35) inverters.
FR-FG
(5VA)
For soft start and stop. Allows parallel operation and
FR-FC
acceleration/deceleration. (3VA)
For synchronous operation. Used with a deviation sensor
FR-FD
and synchro. (5VA)
Can be used as A/V conversion or operational amplifier.
FR-FA
(3VA)
QVAH-10 For follow-up operation. 70/35VAC 500Hz (at 2500rpm)
For synchronous operation (mechanical deviation
YVGC-500W-NS
detection). Output 90VAC/90°
…
For frequency setting. Wire-wound type. 2W1KΩ B
WA2W 1kΩ
characteristic.
…
Dedicated frequency meter (up to 120Hz scale). Moving-
YM206RI 1mA
coil DC ammeter.
…
For calibration of the frequency meter. Carbon-film type.
RV24YN 10kΩ
B characteristic.
Supports steps from inverter start-up to maintenance.
FR-SW0-SETUP-WE
(FR-SW0-SETUP-WJ is Japanese version.)
199
Application, Specifications, etc.
) is required to mount the inverter, with the
……
OPTIONS
Applicable
Inverter
Common to
all models