Epson TM-U925 Manual page 121

· The check waiting status continues until check paper loading starts, the waiting state is
canceled, the waiting time t1 set by ESC f elapses, the printer is reset, or the power is
turned off.
· When rereading of MICR characters is possible with the MICR function selected while
processing this command, the printer re-reads check paper.
· When rereading of MICR characters is impossible with the MICR function selected
while processing this command, the printer ejects the check and ends the MICR
function. In this case, bit 4 becomes On (rereading is impossible) and bit 2 becomes
On (the MICR function is not selected).
· If the detected character cannot be identified with the font specified by n, the printer
converts it to "?" and continues data processing. In this case, the printer ends reading
normally.
· The following cases are abnormal ends:
À MICR characters cannot be detected.
Á The check paper waiting state is canceled.
 The wait time t1 set by ESC f has elapsed while waiting for check paper to be
à An error occurs during the period from the start of command processing to the end
· When MICR reading ends normally, the printer transmits header + reading status +
data + NUL to the host computer. In other cases, the printer transmits header + NUL
to the host computer.
À Header = 5FH (95)
Á Reading status
Bit Off/On
Off
0
On
Off
1
On
2 -
3 -
Off
4
On
Off
5
On
6 On
7 Off
Readable Fonts
Bit 1 Bit 0
0 0
0 1
1 0
1 1
EPSON
loaded.
of the reading operation.
Hex Decimal
00 0
01 1
Readable fonts. Refer to the table below.
00 0
02 2
- - Undefined.
- - Undefined.
00 0 Rereading possible.
10 16 Rereading not possible.
00 0 Reading result. Normal end.
20 32 Reading result. Abnormal end.
40 64 Not used. Fixed to On.
00 0 Not used. Fixed to Off.
Font
E13B
CMC7
Undefined
Undefined
TITLE
TM-U925
Specification
(STANDARD)
Function
SHEET NO.
REVISION
NEXT
A
114
SHEET
113