TEFAL PU4065 Manual page 10

Your replacement filters are available under the following codes:
Filter
HEPA filter
Active carbon filter
NanoCaptur filter
IMPORTANT: Resetting the filters
The reset light flashes when a filter needs to be replaced. Once the filter has been replaced, hold down the reset
button for 2 seconds
Forced reset:
If you have replaced a filter before its end of life, force the reset of the filter replacement cycle:
1. Hold the reset button for 2 seconds
2. Press the reset button briefly to select the filter you have changed.
3. After selecting the filter to reset, hold the reset button for 2 seconds. The electronic meter is then reset.
4. If no button is activated for 10 seconds in forced reset mode, the reset mode is canceled.
« TIPS FOR CHANGING FILTERS »
.
.
Avoid handling used filters if you suffer from allergies or asthma.
.
Wear gloves when changing the filters, or wash your hands well afterwards.
Put used filters directly into a closed, air-tight bag before throwing them away to avoid
spreading pollutants.
Pollution sensors
The particle sensor and gas sensor (model PU6065 only) need to be cleaned regularly (every 2 months) and
appropriately.
Make sure you turn off and unplug the appliance before cleaning the pollution sensors and follow the
recommendations below:
1. Clean the air inlet and outlet using a soft brush or cloth.
2. Open the sensor cover located on the right-hand side of the appliance.
3. Lightly wet a cotton swab and remove any dust from the lens and the inlet/outlet. Wipe using a dry cotton swab.
4. Clean the gas sensor using a soft brush or vacuum cleaner.
1
IMPORTANT:
Never use a detergent or metal object to clean the sensors.
The efficiency of the sensors may be reduced if not cleaned regularly.
Cleaning frequency varies depending on the operating environment of the appliance. If it is used in a dusty
environment, clean the sensors more frequently.
10
.
.
2
Code PU4065
XD6070
XD6060
XD6080
3
Code PU6065
XD6071
XD6061
XD6081
4