Advertisement
Available languages
Available languages
ADJUSTING STITCH
LENGTH
ADJUSTING
OVEREDGE CUTTING
WIDTH
Overedge cutting width can be
adjusted from 4 to 7 mm by simply
turning overedge cutting width dial
according to the kind of fabric.
It is set at standard width of 6 mm
when delivered from the factory.
Turn it towards "5" if fabric edge curls
while sewing. (Fig. 1)
Turn it towards "7 "if loops hang off
the edge. (Fig. 2)
Stitch finger (B)
Loops may hang off the edge, when
you sew with lightweight fabric using
3 threads (right needle only), and
setting cutting width dial at 4
-
5 (Fig.
3). In such a case change the stitch
finger (A) to (B) to get neat stitching
(Fig. 4).
Illustration
*
J : Stitch length dial
"11 : Overedge cutting
width dial
*
III: Stitch finger (B)
"TV: Cross section
Turn the stitch length dial until the
required length is obtained. The
higher the number, the longer the
stitch. This dial can adjust the stitch
length from 1 to 5 mm.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
40
Advertisement
