White W2900 SUPERLOCK Instruction Book page 26

HELPFUL HINTS
REPLACING THREAD SPOOLS
When replacing thread spools, the following steps may be
helpful for quick changeover.
1. Cut off existing threads near the spools. Tie the cut ends
thread from new spools as illustrated (seamens knot).
2. Raise presser foot.
3. Lower needle bar to its lowest position by turning hand
wheel AWAY FROM YOU. Carefully pull the exisbng
threads until the connecting knots pass through needle
eye and looper eyes.
CUTTING NEEDLE THREAD
Frayed thread may make needle threading difficult.
Draw the thread near the thread cutter on the needle plate
and push the thread cutter lever or draw the thread passing
under the moving cutter and turn hand wheel towards you
to obtain clear cut end as illustrated.
I
(
24