Thread Cutter; Changing Presser Feet - White W2900 SUPERLOCK Instruction Book

LINT TRAY
With the lint tray located in this position, it will collect all
your waste material.
After completion of work if you then turn tray upwards in
direction shown, finger Ref C will locate in slot D and left
hand pin will slide into lower hole B.
In either position if you gently push the tray to the left it will
lock more securely into position and avoids the possibility
of it moving out of position.
CUTTING WIDTH GAUGE
When using cutting width gauge, the fabric is cut down and
sewn at same distance from the edge of fabric within the
distance of the width adjuster.
THREAD CUTTER
Thread cutter is built in needle plate. Trim thread near the
end of fabric by pushing down the lever as illustrated.
CHANGING PRESSER FEET
Be sure needle is in the up position. Raise presser foot
lever.
1. Push foot release lever to remove the foot.
2. Place the desired foot on the needle plate aligning needle
holes.
3. Lower the presser foot lever and push foot release lever
so that the foot holder snaps on the foot.
Illustration
* I : Turn upwards
*
JJ : Foot release lever
•
]
14