Unit Construction - Dantherm VentR Installation And Service Manual

1. General
Dantherm heat recovery units type VentR/C are complete ventilation units with frequency-controlled rotary
heat exchanger or cross flow heat exchanger with by-pass, frequency-controlled plug fans, supply air filters
and exhaust air filters as well as a complete, integral electronic control.
Various accessories are offered such as reheat coils for hot water or electricity, multi-leaf dampers, and roof
covering for outdoor installation. This manual is intended for the technician in charge of the commissioning
of the ventilation plant.
1.1

Unit construction

Vent R (pos. left)
1. Fresh air filter F7
2. Exhaust filter F5
3. Supply air fan
4. Exhaust fan
5. Electrical panel and STXC2 print
6. Rotary exchanger
8. Motor for rotary exchanger
Vent C 2/4 (pos. left)
1. Fresh air filter F7
2. Exhaust filter F5
3. Supply air fan
4. Exhaust fan
5. Elec. panel
6. STXC2 print
7. Crossflow heat exchanger
9. By Pass
10. Drip tray with outlet
Installation and service manual
Version 2.5
4