INSTRUCTION SHEET
Telescoping Fence
WARNING
For your own safety, read the machine's instruction manual before
using any accessory. Failure to heed these warnings may result in
serious personal injury and damage to the tool and the accessory.
• Before using the Telescoping Fence, read and follow all
instructions and safety information provided.
• Always keep hands clear of the blade, cutter, sanding disc/belt.
• Before making adjustments to the Telescoping Fence, turn
off the power, allow the blade, cutter or sanding disc/belt to
come to a complete stop and unplug the machine.
• Ensure handle and lock knob are tight before using.
• Before turning on the power after adjustments, ALWAYS verify
there is a safe clearance between the blade and fence.
UNPACKING CONTENTS
NOTE: Check for shipping damage. Check immediately whether
all parts and accessories are included.
ITEM
DESCRIPTION
A
Telescoping Fence, 3"x1-3/8"x20"
B
Lock Knobs
C
12" Movable Scale
Figure 1
WARNING
Risk of accidental starting and serious personal injury.
Unplug the machine before attaching the Telescoping Fence.
THE TELESCOPING FENCE
1. See Figure 2. The I-Beam Extender with 3" Fence End allows
an additional 17" extension. To extend the Fence and/or
switch Fence position, loosen the two Lock Knobs and pull the
3" Fence End out to desired length and secure Lock Knobs.
2. The I-Beam Extender can be used on either end of the Fence. To
change sides, loosen the Lock Knobs, remove the 3" Fence End
with I-Beam Extender. Locate the I-beam profile on the other end
of the Fence and insert I-Beam into the Fence. Tighten Knobs.
Figure 2
INSTALL THE FENCE ONTO
A MITER GAUGE (
Figures 3-4. Shown using POWERTEC 71767 Miter Gauge
(Sold separately)
3. See Figure 3. Remove Fence Lock Knob. Loosen the two
5/16" Round Knobs on the Miter Gauge and slide the T-bolts
into the Fence slot.
Figure 3
QTY
1
4. See Figure 4. Insert I-Beam Extender with 3"Fence End.
2
Set to desired length. Tighten 5/16" Round Knobs on Miter
1
Gauge. Reinsert Fence Lock Knobs and tighten to secure
I-Beam Extender in position.
Figure 4
Model No. 71768
Not Included)
23-0306