Table of Contents
Advertisement
Power supply
Connect the supplied power cord in the following order. Make sure the [STANDBY/ON] switch on the instrument is set to the
Standby position.
1.
Connect the supplied power cord to the AC IN
terminal on the instrument's rear panel.
2.
Connect the other end of the power cord to an AC
outlet.
WARNING
Use only the power cord supplied with your instrument. The power cord
supplied with your instrument must not be used with any other electrical
devices. Failure to observe this precaution can result in the equipment being
damaged, overheated or cause a fire.
WARNING
When setting up the product, make sure that the AC outlet you are using is easily accessible. If some trouble or malfunction occurs,
immediately turn off the power switch and disconnect the plug from the outlet.
NOTE
Follow this procedure in reverse order when disconnecting the power cord.
Connecting speakers or headphones
Since this instrument has no built-in speakers, you will need to monitor the sound of the instrument by using external
equipment. Make sure to turn off any keyboard amplifiers, monitor speakers, and other devices, and then connect a set of
headphones and any other devices as shown below. When making connections, be sure that your cables have the appropriate
ratings.
30
MONTAGE M Quick Guide
Setting up
Keyboard amplifier
or
Monitor speakers
(left)
Headphones
OUTPUT (BALANCED)
[L/MONO] jack
[PHONES] jack
Keyboard amplifier
or
Monitor speakers
(right)
OUTPUT (BALANCED)
[R] jack
Rear panel
[AC IN] jack
Power cord (included)
Advertisement
Table of Contents
