Fanimation WRAP MAD8530 Series Manual page 2

WARNING: To avoid fire, shock and serious personal injury, follow these instructions.
1. Read your owner's manual and safety information before installing your new fan. Review the accompanying
assembly diagrams.
2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting
means to prevent power from being switched on accidentally. When the service disconnecting means cannot
be locked, securely fasten a warning device, such as a tag, to the service panel.
3. Be careful of the fan and blades when cleaning, painting, or working near the fan. Always turn off the power
to the ceiling fan before servicing.
4. Do not insert anything into the fan blades while the fan is operating.
5. Do not operate reversing switch until fan blades have come to a complete stop.
6. The appliance is not intended for use by young children or infirm persons without supervision. Young children
should be supervised to ensure that they do not play with the appliance.
1. To avoid possible shock, be sure electricity is turned off at the fuse box before wiring, and do not operate
fan without blades.
2. All wiring and installation procedures must satisfy National Electrical Codes (ANSI/ NFPA 70) and Local
Codes. The ceiling fan must be grounded as a precaution against possible electrical shock. Electrical
installation should be made or approved by a licensed electrician.
3. The fan base must be securely mounted and capable of reliably supporting at least 35 lbs. See page 5 of
owner's manual for support requirements. Consult a qualified electrician if in doubt.
4. The fan must be mounted with the fan blades at least 7 feet from the floor to prevent accidental contact
with the fan blades.
5. Follow the recommended instructions for the proper method of wiring your ceiling fan. If you do not have
adequate electrical knowledge or experience, have your fan installed by licensed electrician.
6. Suitable for use with solid-state speed controls.
7. This fan is to be used in damp locations.
8. Use only with light kits marked suitable for use in damp locations.
9. For supply connections, if the conductor of a fan is identified as a grounded conductor, then it should be
connected to a grounded conductor power supply. If the conductor of a fan is identified as an ungrounded
conductor, then it should be connected to an ungrounded conductor power supply. If the conductor of a
fan is identified for equipment grounding, then it should be connected to an equipment grounding
conductor.
10. Turn off wall control can override any smart enabled appliance or remote control commands.
11. The remote control of this product contain lithium button/coin cell batteries. If a new or used lithium
button/coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead
to death in as little as 2 hours. Always completely secure the battery compartment. If the battery com
partment does not close securely, stop using the remote control of the product, remove the batteries,
and keep it away from children. If you think batteries might have been swallowed or placed inside any
part of the body, seek immediate medical attention.
- The cells shall be disposed of properly, including keeping them away from children.
- Even used cells may cause injury.
WARNING: Chemical Burn Hazard. Keep batteries away from children.
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS FAN MUST BE INSTALLED WITH A
GENERAL USE ISOLATING WALL CONTROL/SWITCH.
WARNING: This product is designed to use only those parts supplied with this product and/or accessories
designated specifically for use with this product. Using parts and/or accessories not designated for use with this
product could result in personal injury or property damage.
WARNING: To reduce the risk of personal injury, do not bend the blade when installing the blade, balancing the
blade, or cleaning the fan. Do not insert foreign objects in between rotating fan blade.
WARNING: Do not operate this fan with a variable (Rheostat) wall controller or dimmer switch. Doing so could
result in damage to the ceiling fan's remote control unit.
WARNING: Mount to an outlet box marked acceptable for fan support of 15.9 kg (35 lbs) or Less.
WARNING: To reduce the risk of fire, electric shock, and injury to persons, ceiling fan, model Wrap Custom must
be installed with optional fan blades indicated in Page 31 or 32, that are marked on their cartons to indicate the
suitability with this model. Other blades cannot be substituted.
WARNING: To Reduce The Risk Of Fire, Electric Shock Or Injury To Persons, Do Not Use Replacement Parts
That Have Not Been Recommended By The Manufacturer (e.g. Parts Made At Home Using A 3D Printer).
Important Safety Instructions
Additional Safety Instructions