Fanimation WRAP MAD8530 Series Manual page 15

How to Operate Your Ceiling Fan (Continued)
5. If you have multiple fans and want to program all
fans to one handheld control. Slide the Dip Switches
to the same position in ALL receivers as ONE
handheld control, then follow Step 1 of the remote
control speed set up process. Each fan needs to be
no more than 30 feet from the handheld control that
you would like to program. Please note the wall switch
that controls the power to your fan(s) should be in the
off position until you are ready to program your
handheld remote(s).
6. If you have multiple fans and want to program
each fan to separate handheld controls, slide the Dip
Switches to the same position in both receiver and
handheld control, then follow Step 1 of the remote
control speed set up process below for each fan.
Repeat these steps for each fan that you would like to
program to a separate handheld remote. Please note
that the wall switch that controls the power to your
fan(s) should be in the off position until you are ready
to program your handheld remote(s).
7. To set the remote code in the same positions as
the receiver, use a small screwdriver or ball point pen
(neither included) to slide dip switches firmly up or
down. (Figure 5)
NOTE: Factory setting is all up. Do not use this
position.
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference
from or to other remote units, simply change the
combination code in the remote and receiver.
Remote
Control
Dip Switch
15
Figure 5