Fanimation WRAP MAD8530 Series Manual page 16

How to Operate Your Ceiling Fan (Continued)
8. Remote Control Speed (RPM) Setting Process :
(Figure 6)
1) After installing and wiring the unit, restore power to
your fan by ensuring that the breaker and wall switch
that controls the power supply is moved to the on
position, press and hold the "LEARN" button inside of
the battery compartment of the handheld remote
control for 1-3 seconds.
2) You must press the "LEARN" button within 30
seconds of restoring power to the fan.
3) When restoring power to your fan at the wall switch
and breaker, DO NOT press any button(s) on the
handheld remote control before pressing the "LEARN"
button, otherwise the fan will fail the learn procedure.
4) If you press any button(s) on the handheld remote
control before pressing the "LEARN" button, please
turn the wall switch that controls the power to the fan
to the off position then on again, and start the process
beginning with Step 1 above.
5) When you press the "LEARN" button, the fan
will make one musical sound and light blink once,
if equipped with a light, and start to run, beginning
the control set up process.
6) DO NOT press any button(s) after pressing the
LEARN button while the fan is programming or it will
fail to program.
7) The fan will run in forward direction for
approximately 3 minutes.
8) When the fan stops running after approximately 3
minutes, the fan will make two musical sounds and
light will blink twice, signaling that the handheld
remote control and speed set up process is complete.
9) The fan is now ready for normal use.
NOTE: If you want to change the blades: turn the
power off → change the blades → turn the power
on → perform the control setting process.
9. Replace battery cover on the remote control and
secure with the previously removed screw. (Figure 7)
16
LEARN
Figure 6
Figure 7