Installing The Wall Bracket; Initial Startup; Operation - Kärcher VC 4 Cordless myHome Original Instructions Manual

Crevice nozzle
17
Wall bracket
18
Charger
19
** 2-in-1 upholstery nozzle
20
** Flexible extension hose
21
** Flexible crevice nozzle
22
** Large upholstery nozzle
23
** 2-in-1 furniture brush
24
** Mini turbo brush
25
** Soft brush
26
** LED crevice nozzle
27
** Air inlet filter
28
** Filter cleaning tool
29
** Soft motorized brush (hard floor nozzle)
30
** optional

Installing the wall bracket

The scope of delivery includes a wall bracket as well as
screws and dowels for tidy storage of the vacuum clean-
er.
Note
Mount the wall bracket at a suitable point using the
screws and dowels supplied.
For safe storage of the device, position the lower edge
of the wall bracket 1.04 m from the floor.
Illustration E
ATTENTION
Material damage due to incorrect installation
Incorrect installation can damage both the device and
the floor covering if it falls.
Use suitable mounting tools for wall mounting.
Take the weight of the device and the loading capacity
of the installation location into account when selecting
the fasteners.
WARNING
Risk of electric shock and injuries
Make sure there are no electrical cables, water or gas
pipes in the wall around the mounting area.

Initial startup

Installing accessories
Note
The multi-function brush is also driven by its own inte-
grated motor and must therefore always be connected
directly to the hand-held device or the suction pipe in or-
der to ensure the power supply.
All other accessor parts can also be used directly with
the hand-held device or with the suction pipe to increase
the reach.
 Push the suction pipe on to the suction fitting of the
dust container until it audibly clicks into place.
 Press the unlocking button and remove the suction
pipe from the suction fitting.
Illustration B
 Push the floor nozzle on to the suction pipe until it
audibly clicks into place.
16
 Press the unlocking button and remove the floor
nozzle from the suction pipe.
Illustration C
 Push the accessory, such as the crevice nozzle, on
to the suction fitting of the dust container or suction
pipe until it audibly clicks into place.
Illustration D
Note
The device is not supplied with a charged battery. Fully
charge the battery before using it for the first time.
Please observe the enclosed safety instructions for bat-
tery powered vacuum cleaners.
1. To charge the device, attach it to the wall bracket in-
cluded in the scope of delivery.
Illustration E
2. Plug the charger into a socket.
Insert the connecting plug into the charging socket
of the device.
The LED indicator light flashes green during the
charging process.
Illustration F
3. When the device is fully charged, the LED indicator
light lights up continuously green for 2 min. and then
goes out.
Remove the charger from the power socket and
charging socket.
Remove the device from the wall bracket.
Illustration G
The device is ready for use.
The LED on the head of the device shows information
on the charging state of the battery and error messages.
Battery charging state
LED Duration of
lighting
Lights up continuously
green
Flashes 1 s on / 1 s off
green
Flashes 125 ms on / 125
green ms off
The progress of charging the battery can be read from
the green LED. The LED only lights up when the battery
is correctly installed.
While charging
LED Duration of
lighting
Flashes 0.2 s from off to
green on /
0.6 s on /
0.2 s from on to
off /
1 s off
Lights up 2 min continu-
green ous lighting,
then off
English
Battery charging

Operation

LED display
Meaning
Battery charged
2 min remaining running
time (-1 min/+2 min)
Battery fault
Meaning
Battery is charging
Battery fully charged