Setting the Mold Alarm
Press and hold
°C/°F
Press
or
Press
°C/°F for 3
Sec and wait for 10
Sec
As soon as the humidity rises over the value set by you the
symbols MOLD ALERT appear in the display and the red LED
alarm signal flashes.
To end the alarm press any button.
The symbols MOLD ALERT remain on the display until the
detected humidity drops under the set values.
The factory setting for the mold alert value is 65%.
Read and reset MIN-/MAX Values
To read the MIN and MAX values of temperature respectively
relative humidity, briefly press the MAX/MIN Button.
Hold the MAX/MIN button to reset the respective values and start
a new recording.
Operation
MOLD ALERT Appears in the Display
and the Humidity Display flashes
Set a value for the upper Mold Threshold
(can be set from 60 to 75 %)
Display returns to normal Mode
17